02-06-2013 01:28 PM - edited 03-11-2019 05:56 PM
I need to configure the following on my PIX:
TCP port 2195 - outbound
TCP port 2196 - inbound
How would I configure this via ASDM?
02-06-2013 01:49 PM
Hi,
Are you simply talking about some host on behind the PIX that has a Static NAT configured and needs the following opened
Or are we perhaps talking about some sort of Port Forward configuration?
- Jouni
02-06-2013 02:05 PM
It would be two hosts behind the PIX (2195 used to send notifications; 2196 for feedback). They will both have static IP addresses on my 10.x network. Vendor will be onsite next week for setup.
02-06-2013 02:30 PM
How many public IP addresses do you have available? Do you only have the "outside" interface public IP address of the PIX itself or do you perhaps have a small subnet of public IP addresses available on the PIX?
If you only have a single public IP address on the PIX and cant configure a separate public address for the actual host/hosts on the LAN, then for the traffic/connections that are coming from the "outside" you will need to do a Port Forward / Static PAT configuration to be able to reach the LAN host from the Internet on the mentioned "inbound" TCP port
- Jouni
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide