PDM Installation

[mcpcca]

I have a ASA5510 that I performed a write erase on now my PDM does not work even after running the setup from the CLI. Do I need to reinstall or TFTP the PDM back on the ASA?

[sachinraja]

Hello,

The PDM will remain the software, even if you write erase or reboot.. since u have written off all the configs, the http access to your ASA would have been lost... you need to re-enable the http access to your ASA using the "http enable" command.. also go to the console and check for the IP addresses on the interfaces...

hope this helps.. all the best..

RAj