Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having an issue with getting our email, web, etc. forwarded to our internal servers. We have a ASA 5520 running version ASA Version 7.0(6). The issue I have is that our "Outside" interface is a natted address, not a real "Public" address. The I...
I have a ASA5510 that I performed a write erase on now my PDM does not work even after running the setup from the CLI. Do I need to reinstall or TFTP the PDM back on the ASA?
I have a Cisco 2801 router with two ethernet interfaces in it. I applied the IP addresses given to me from my ISP on fa0/1 interface and set my default route to point to their router. I then applied the other ip addresses given to me from the ISP t...
I have 2 CAT 3524 XL switches trunked together. I have 2 different subnets one on each switch that I want to have our DHCP server give out different address depending on which subnet they come from. I have IP Helper commands on each Vlan pointing to ...
We have a 4506 w/ 18 port GB blade and SX inserts. I have a fiber connection to a 2950G switch. I have a link on the 2950 gi0/1 but no link on the 4506 fiber connection. The sho int gi2/11 on the 4506 shows connection down. But if i unplug the fiber ...
Thanks for the help guys, I got it fixed. I had done two configs one with static routes and the other with just my default route to the next router.It was a problem with the ISP, they did not have the second set of IP addresses setup on their end to...
So I don't need any static routes even if both ethernet interfaces are on different networks? I did thry the speed and duplex settings but still no luck. ThanksScott
