Hello Could you please help.
I was testing pix 501 for the first time. Upgraded it to 6.21.I got it configured and after booting it, it lost its eth 1 interface. Now it does not come up at all. I would say that interface is broken, but we wer
Here is
Cisco PIX Firewall Version 6.2(1)
Licensed Features:
Failover: Disabled
VPN-DES: Enabled
VPN-3DES: Enabled
Maximum Interfaces: 2
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: 10
Throughput: Limited
IKE peers: 5
Not enough supported network interface cards installed.
PIX requires at least 2 supported interface cards,
but only 1 supported interfaces were found.
Rebooting....
CISCO SYSTEMS PIX-501
Embedded BIOS Version 4.3.200 07/31/01 15:58:22.08
Compiled by morlee
16 MB RAM
PCI Device Table.
Bus Dev Func VendID DevID Class Irq
00 00 00 1022 3000 Host Bridge
00 11 00 8086 1209 Ethernet 9
Cisco Secure PIX Firewall BIOS (4.2) #6: Mon Aug 27 15:09:54 PDT 2001
Platform PIX-501
Flash=E28F640J3 @ 0x3000000
Use BREAK or ESC to interrupt flash boot.
Use SPACE to begin flash boot immediately.
Flash boot interrupted.
Please select an interface from 0 to 0
Ethernet port 1 could not be initialized.
TIA
Susanna
