PIX 501 & pcAnywhere

[mellc]

On a PIX 501 (6.1) with one static IP on a DSL connection, how can I open the tcp 5631 and udp 5632 ports for a pcAnywhere connection from one specific source/external IP to one specific host on the internal network?

I'm using PAT -- global (outside) 1 interface

NAT is set with -- nat (inside) 1 0.0.0.0 0.0.0.0

I've tried access-list:

access-list acl_out permit tcp host sss.sss.sss.sss eq 5631 host ddd.ddd.ddd.ddd eq 5631

access-list acl_out permit udp host sss.sss.sss.sss eq 5632 host ddd.ddd.ddd.ddd eq 5632

access-group acl_out in interface outside

I've tried conduit:

conduit permit tcp host ggg.ggg.ggg.ggg eq 5631 host sss.sss.sss.sss eq 5631

conduit permit udp host ggg.ggg.ggg.ggg eq 5632 host sss.sss.sss.sss eq 5632

======================

Do I need to use with the static command and to have a second public IP address for that? Can I use a nat (inside) 0 access-list acl_out command along with my existing nat and global settings?

Again, I only want access to one particular machine behind the PIX.

Thx,

[yusuff]

Basics first:-

- you need to create a static command and conduit/ACL for any traffic initiated from outside to inside.

- nat/global statements only work for traffic initiated from inside to outside.

Now, for your problem, you need to create a static and do port redirection.

http://www.cisco.com/warp/public/707/28.html#port

Hope that helps

R/Yusuf

[jerry.roy]

Hello all,

I have a conduit command on my PIX that allows a ping from workstations on my lan to reach a remote machine across the net.

conduit permit icmp host 65.165.98.171 170.31.92.16 255.255.255.252

The host ip above is my (outside) IP address on my PIX. How can I accomplish the same thing with an access-list?

I believe NAT allows all (pings) out but the reply just cannot get back in. Do I place an access-group on the (outside) interface "in"

Thanks,

Jerry Roy