Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone know how to do this? I heard from Cisco and have actually done this once but don't remember the syntax.I should be able to insert acl 15 between the lower 2.Extended IP access list 198 10 permit ip any any 20 deny ip any anyTIA
Anyone know how to do this? I heard from Cisco and have actually done this once but don't remember the syntax.I should be able to insert acl 15 between the lower 2.Extended IP access list 198 10 permit ip any any 20 deny ip any anyTIA
Anyone know how to do this? I heard from Cisco and have actually done this once but don't remember the syntax.I should be able to insert acl 15 between the lower 2.Extended IP access list 198 10 permit ip any any 20 deny ip any anyTIA
I need to know if it is possible to Nat out 2 interfaces on a 831 with Split tunneling using same lan space. I have hundreds of branch offices that need one to one nat via tunnel (unique space in tunnel, same space on lan of each branch, they do not ...
I need to know if it is possible to Nat out 2 interfaces on a 831 with Split tunneling using same lan space. I have hundreds of branch offices that need one to one nat via tunnel (unique space in tunnel, same space on lan of each branch, they do not ...
I pinged from the router itself to populate the arp cache. An end user on the LAN (192.168.1.0/24) was only able to reach hosts after I ping the host first from the 1711 router. I have decided to change my direction and NAT to internet and Route to D...
Nope, doesnt work. Users on LAN can get to the DMZ only after I have ping a host on the DMZ and populated the Arp cache on the cisco. I tested with an end user today and they could not ping anything and I proceeded to ping each host on dmz one by one...
