cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
612
Views
0
Helpful
2
Replies

Pix 515 4-port ethernet interface issue

neal.miller
Level 1
Level 1

Why does my PIX not see all 4 ports on the 4 port ethernet interface card. It only sees 1. Here is a sho ver

Result of firewall command: "sho ver"

Cisco PIX Firewall Version 6.3(4)

Cisco PIX Device Manager Version 3.0(2)

Compiled on Fri 02-Jul-04 00:07 by morlee

itf-gw-01 up 56 mins 18 secs

Hardware: PIX-515, 32 MB RAM, CPU Pentium 200 MHz

Flash i28F640J5 @ 0x300, 16MB

BIOS Flash AT29C257 @ 0xfffd8000, 32KB

0: ethernet0: address is 0003.6bf6.88ef, irq 11

1: ethernet1: address is 0003.6bf6.88f0, irq 10

2: ethernet2: address is 000d.88ef.43dc, irq 9

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES-AES: Enabled

Maximum Physical Interfaces: 3

Maximum Interfaces: 5

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Unlimited

IKE peers: Unlimited

This PIX has a Restricted (R) license.

serial number omitted

Running Activation Key: omitted

Configuration has not been modified since last system restart.

Thanks all

2 Replies 2

jboyer
Level 1
Level 1

You have a Restricted license. You need the Unrestricted license for more than 3 total interfaces. You can purchase a R-UR upgrade license, enter the new key and viola, all your interfaces will work!

richcobb99
Level 1
Level 1

I had the same problem. You need to have an UR or unrestricted license for the 4 port card to work. You have an R or restricted license.

Hope this helps.

rich

Review Cisco Networking for a $25 gift card