Network Security

Hi everyone,I want to schedule a PIX reload once a week.It this possible ?Because the way I am doing today, is via telnet, enter pix configuration and execute the reload command.Thanks Santiago

I'm new to PIX so forgive me if I'm a little dumb :-)I have two PIX 501's at two offices. I want to connect them together into a VPN so that the users at each office can access the servers and resources at the other office.Should I use the EasyVPN ja...

PIX VPN client users are authenticated via VPNGROUP and associated preshared password, now I want to authenticate also via RADIUS. The authentication works fine, but is it possible to delegate the RADIUS server to push network parameters like IP addr...

EnviromentCiscoVPN(CLIENT)---PsssThruPix---Internet---RemotePix I want established a VPN tunnel to the romtePix, but i always got the logging message 305006.What's wrongPIX Version 6.2The authentication is ok....esp and udp/500 is permitted on the ou...

Hi,Can I configure the PIX cut-through proxy feature to authenticate using a local user database and have different access-lists for each user - all defined on the PIX rather than in a RADIUS server? If so, what commands shoudl I use?ThanksStuart

Got a question for how to configure Global (outside) NAT or PAT if the PIX is behind a multihomed (non BGP)router. The 1720 router has connections to two seperate ISPs for WAN redundantancy. My question is if ISP B will not route ISP A IP addresses i...

is there any way to block popups with pix ? any other info is appreciated

Hello,i have a PIX 515e with Software Version 6.3(1).Ok - i am new to the pix but i can read manuals ...The pix has a runnig-config which i like to change.But i have a problem with the line numbers of the access-lists.As a test i tried to insert a re...

Hi, I'm checking out whether changing UDP ports is possible on a PIX 525(6.3(4)). A RADIUS request sent from host on DMZ network with UDP port 1812 through the PIX to the RADIUS Server on inside network. RADIUS server replies on 1647 but DMZ host exp...

I have several PIXs at remote offices that all come into a "main" PIX at our main office. My network has been going up and down for the past few days. I have been running the debug crypto isakmp command periodically to find out what's going on. Do...

Hi all,I want to setup Cisco Pix to allow Terminal Service traffic from outside.Here is what I did:"access-list outside100 permit tcp any host 63.207.35.51 eq 3389static (inside,outside) tcp 63.207.35.51 3389 192.168.166.200 3389 netmask 255.255.255....

I've PIX501E with with licence for 10 users. Is it possible to increase licence for this device ( to buy new licence) or necessary to buy new device with license for 50 users?

Hi,I have 2 Pix 520 in stateful failover working well for a year. Today these units chashes at the same time twice.What can I do for obtain an explanation of this issue.---------------------------------------------------Version 6.2(2).Hardware: SE440...

Is there a way to have multiple IP's on the Outside interface NAT to the same IP in my DMZ.For example, I have a web server at 172.16.1.9(DMZ) and I want to have all connections to 10.10.10.1, 10.10.10.2 and 10.10.10.3(Outside IP's) natted to the 172...