I have a PIX 515.
Since today I have the following problem:
The PIX is connected to COM1 to a configuration workstation.
I have configured HyperTerminal (W2K3 version, but also tried TeraTerm Pro Web 3.1.3) to connect to the PIX with 9600 8-N-1.
I power cycle the PIX and I see the boot message, to press SPACE to go directly to flash boot, and ESC or BREAK to stop flash boot. At this point I'm already unable to enter a keyboard command. SPACE doesn't end the boot countdown and doesn't boot the flash immediately. And sending BREAK or ESC doesn't stop the PIX from booting the flash.
After the boot countdown, the flash configuration is booted without a problem. After the command prompt appears, I'm still unable to enter any keyboard commands. But I'm able to ping the inside und outside IP addresses which I already configured yesterday. So the PIX itself is obviously not crashed.
I can not connect by telnet, because I haven't configured telnet access yet.
I already tried other terminal software, I tried an other workstations, I switched the console cable. But nothing helped me to solve this.
Any help?
Thanks
Frank Hofmann