06-21-2007 03:19 AM - edited 03-11-2019 03:33 AM
i have pix515E IOS 7.04 installed at my network. yesterday i worked and configure pix interfaces, static NAT, syslog, static routes and access-list and then i left the next morning i came office and try to use NET there is no response, i check syslog there is nothing there, i connect to pix through console and i checked interfaces its working and "UP" i checked wire, switch port i ping my pc but it didnt respond but other 2 interface are working fine i.e outside and dmz but inside not working .......... can any one give me some idea why this happen???
how i can resolve this mystery................
thanks
Naveed
06-22-2007 10:06 AM
If your PC can not ping the PIX, then you may have a ACL not allowing.
Can you ping from PIX to your PC?
from PIX to Internet?
These could be ACLs you are missing.
06-25-2007 12:12 AM
i allowed the PC to ping to PIX but only the inside interface didn't response, when i reboot the pix it start responding. i didn't understand the problem why pix behave like this,
please help and thanks for response.
06-25-2007 02:27 PM
The PIX can be a good device to use but sometimes it does too much good. If you don't put a command to allow echo-replies, when you ping the pix it will not respond to you. Mind you, you could be hitting it, but without the proper commands on the PIX, it will not respond back. Same goes for traffic, if you don't allow traffic to the outside, it will not let you get out. I hope this makes sense.
Thanks and let me know if it doesn't.
Julio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide