PIX 515 url access
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2006 02:59 AM - edited 02-21-2020 12:42 AM
Hi,
I would like to configure my PIX 515 to allow the internet access only to one web site. I would like to use the url address and not the IP address.
Can I use class-map ? And what are the commands I have to use ?
Thanks in advance
Romain Page
- Labels:
-
Other Network Security Topics
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-20-2006 07:01 AM
I think the following URL will give you some idea on this. Refer the following document and let me know if you still have any problem or confusion
http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00800c525f.shtml
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2006 03:00 AM
As far as I can see in PIX you can't filter locally using domains but you can get a workaround by using the IP address or by deploying a proxy / content engine at the customer premises.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-21-2006 01:07 PM
How about Websense?
