PIX 515 url access

[romainpage]

Hi,

I would like to configure my PIX 515 to allow the internet access only to one web site. I would like to use the url address and not the IP address.

Can I use class-map ? And what are the commands I have to use ?

Thanks in advance

Romain Page

[b.hsu]

I think the following URL will give you some idea on this. Refer the following document and let me know if you still have any problem or confusion

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a00800c525f.shtml

[fausto-oliveira]

As far as I can see in PIX you can't filter locally using domains but you can get a workaround by using the IP address or by deploying a proxy / content engine at the customer premises.

[mpalardy]

How about Websense?