PIX 515 with subnet and VLANs

[godspeed01]

I am having some problems getting computers in other subnets and VLANs to connect to the PIX515.

Ping and PDM no responses.

Using a computer in the same subnet as the PIX515, I am able to connect to it.

However I was not able to connect to it from other computers in different subnet.

Using these computers I was able to connect to devices in the same subnet as PIX515.

Is there configuration problem on the 515 side?

PIX ip: 10.58.88.10, subnet 10.58.88.x

gateway 10.58.88.2

other subnets: 10.58.86.x, 10.58.87.x, 10.58.89.x

their gateways: 10.58.86.1, 10.58.87.1, 10.58.89.1

[Steven Bourque]

Try NAT'ing your traffic from the higher security to an IP the lower security subnet when accessing the lower security.

This will create an xlate entry to allow the return traffic from the lower security back to the higher security.

Apprantly this has been changed in ver 7.0. I assume you are using 6.x or something.

I can supply some configs if required.

[godspeed01]

I had placed a route (inside interface) to direct all subnet traffic to my switch. Apparrently this works.