PIX 515E FAILOVER

[pgasol]

Hi everybody

I'm trying to configure failover in two pix 515E following the instructions of the Installation Guide. I've connected the failover cable properly (not using Stateful Failover) but when I write "show failover" in the CLI of the primary unit, next message is displayed:

Cable status: my side is not connected

This host: Secondary - active

Can anybody tell me what's happening?

Thanks in advance

[yusuff]

The failover cable is marked "primary" and "secondary".

It looks like this side of PIX is secondary, but the cable is not plugged in correctly, try removing it and re-plug it properly on both ends.

HTH

R/Yusuf

[bwhitaker]

Have you reviewed the release notes for the code you are running on the firewalls? I would also take the time to do a bug check. This might be of some assistance.