PIX 525 Reload

[ggozzi]

Hy

I have a problem with 2 pix 525 in lan statefull failover the software version is 6.2.2:

Sometimes when I issue a "no debug ....... command from an ssh session,

the active pix reboot and the secondary pix take control.

In the syslog with trap level warning there is only the switch over event.

Any suggestion?

Thanks and regards

[raymong]

I have seen this problem once before... the person that had this problem with 6.2.2 decided to wait until 6.3 was released so I am not certain that the upgrade resolved the problem. If you did not have this problem before on 6.1, you could either upgrade or downgrade to get around this problem.