Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is a url that addresses some of the problems of upgrading the AP1200 to run IOS:http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtml
Here is a url with more information on configuring access lists:http://www.cisco.com/pcgi-bin/Support/browse/psp_view.pl?p=Internetworking:ACCESS-LIST_ARP_BOOT_DHCPTo permit traffic to your webserver, you will need to configure an acl and permit traf...
Take a look through the following url that explains What Causes "Bad CPU ID" Messages:http://www.cisco.com/en/US/products/hw/routers/ps341/products_tech_note09186a00800a7317.shtml
Take a look through the url for more information on dynamic access lists:http://www.cisco.com/en/US/products/sw/iosswrel/ps1828/products_configuration_guide_chapter09186a00800ca600.html#3906
Unfortunately the only way these counters can be cleared is by reloading the router.The reason for this is most of the stats are not directly accessible, they are displayed by making registry calls to the various active and registered protocols, so t...
