Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
276
Views
0
Helpful
1
Replies

PIX Failover configuration

arumugasamy
Level 1
Level 1

‎06-30-2005 06:32 AM - edited ‎02-21-2020 12:14 AM

Dear All,

In the data centre network environment,

I have to install 2 pix firewall in the failover configuration.The inside interfaces of both the pix has to be connected to the 2 core switches 4507R in reduntant mode.

I am looking for the best methods to implement this failover method cited above.

Anyone pls help me with the design and config stuffs.

Thanks in regards,

swamy

0 Helpful
1 Reply 1

p.krane
Level 3
Level 3

‎07-06-2005 07:01 AM

This document explains the procedure of configuring the pix failover.... http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_configuration_guide_chapter09186a008017278a.html

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card