Pix 6.2
Eth5 is my failover interface conneting via a layer 2 switch
FW# show failover
LAN-based Failover is Active
interface fo (x.x1.1): Normal, peer (x.x.1.2): Unknown>>>>>>>>>>>>>>>>>>>
FW#sh interface ethernet5
interface ethernet5 "fo" is up, line protocol is up>>>>>>>>>>>>>>>>>>>>> I don’t think it’s a cable issue
MTU 1500 bytes, BW 100000 Kbit full duplex
0 packets input, 0 bytes, 0 no buffer>>>>>>>>>>>>>>nothing coming from the switch
Received 0 broadcasts, 0 runts, 0 giants
952 packets output, 57162 bytes, 0 underruns>>>>>>>>>>>>>>>>>>>> leaving traffic from the FW
I don't have access to the layer 2 switch as there is no ip in it .
However they are in the same VLAN .
Any susggestion?