Hi,
When i attempt to upgrade the PIX Software, on my "PIX Classic Firewall"
i get the below error. Do i need to change any Dip switch settings on the Flash card (ISA)?
I get the below error when i boot of the boothelper disk.
I have a 2MB Flash card. I am trying to load 5.29. Should i try an earlier version? if so where can i locate it?
Thanks
Booting Floppy
...................................Execing flop
Cisco Secure PIX Firewall floppy loader (3.0) #0: Tue Sep 11 07:34:46 PDT 2001
Reading installation media..............
32MB RAM
mcwa i82558 Ethernet at irq 11 MAC: 0090.2726.ffff
mcwa i82558 Ethernet at irq 10 MAC: 0090.2727.0013
Flash=AT29C040A @ 0x300
Obsolete FLASH card. Upgrade required. See release notes for this version.
-----------------------------------------------------------------------
|| ||
|| ||
|||| ||||
..:||||||:..:||||||:..
c i s c o S y s t e m s
Private Internet eXchange
-----------------------------------------------------------------------
Cisco PIX Boothelper
Cisco PIX Firewall Version 6.1(1)
open(ffsdev/2/read) failed
An internal error occurred. Specifically, a programming assertion was
violated. Copy the error message exactly as it appears, and get the
output of the show version command and the contents of the configuration
file. Then call your technical support representative.
assertion "fdf_init()" failed: file "bh_main.c", line 146
No thread name
