Hi,
Am upgrading the 6.1 to 6.23 on PIX 525 , and am getting error
monitor> interface 1
0: i8255X @ PCI(bus:0 dev:14 irq:10)
1: i8255X @ PCI(bus:0 dev:13 irq:11)
2: i8255X @ PCI(bus:1 dev:0 irq:11)
3: i8255X @ PCI(bus:1 dev:1 irq:10)
4: i8255X @ PCI(bus:1 dev:2 irq:9 )
5: i8255X @ PCI(bus:1 dev:3 irq:5 )
Using 1: i82557 @ PCI(bus:0 dev:13 irq:11), MAC: 000b.5f57.4331
monitor> address 192.168.17.1
address 192.168.17.1
monitor> server 192.168.17.5
server 192.168.17.5
monitor> file pix623.bin
file pix623.bin
monitor> ping 192.168.17.5
Sending 5, 100-byte 0xe3e9 ICMP Echoes to 192.168.17.5, timeout is 4 seconds:
!!!!!
Success rate is 100 percent (5/5)
monitor> tftp
tftp pix623.bin@192.168.17.5...........................
.......................................
Received 128336 bytes
Cisco Secure PIX Firewall admin loader (3.0) #0: Thu Jul 17 08:02:52 PDT 2003
System Flash=E28F128J3 @ 0xfff00000
BIOS Flash=am29f400b @ 0xd8000
imgsum_config: sumval(0x8b74) md5(0xc57589e0 0xec398acd 0x6558d7bb 0x10dd9677)
imgsum_verify: chksum(0x0 ) md5(0xdcd45e93 0x125e91b5 0x374d26ac 0x0f6336ce)
Checksum verification on install image failed ********
also from tftp ---
Int-fw-1# copy tftp flash
Address or name of remote host [127.0.0.1]? 192.168.17.5
Source file name [cdisk]? pix623.bin
copying tftp://192.168.17.5/pix623.bin to flash:image
[yes|no|again]?y
!!!!!!!!!!!!!!!!!!!!!!!!!!
Received 128336 bytes.
Checksum verification on new image failed.
Image not installed.
Int-fw-1#
and my firewall is rebooting , Can any one have idea about this
Thanks
