I have pix 525 with 8.x IOS. earlier i have the serial base failover it was working fine, but when i try to configure this pair with lan to lan failover. I m not able to configure this.
I tried with cross cable used for lan to lan failover and also try with making sepearte vlan for lan base failover cable.
First i configure the primary firewall with the below commands
failover
failover lan unit primary
failover lan interface failover Ethernet2
failover replication http
failover link state Ethernet3
failover interface ip failover 192.168.96.1 255.255.255.0 standby 192.168.96.2
failover interface ip state 192.168.97.1 255.255.255.0 standby 192.168.97.2
When i paste these commands i got this messsage
At that time secondary firewall was not power up.
Then I power up the secondary firewall and configure the following commands and also no shut the stateful and lan interfaces
pixfirewall(config-if)# failover lan unit secondary
pixfirewall(config)# failover lan interface failover Ethernet2
INFO: Non-failover interface config is cleared on Ethernet2 and its sub-interfaces
pixfirewall(config)# failover replication http
pixfirewall(config)# failover link state Ethernet3
INFO: Non-failover interface config is cleared on Ethernet3 and its sub-interfaces
pixfirewall(config)# failover interface ip failover 192.168.96.2 255.255.255.0$
pixfirewall(config)# failover interface ip state 192.168.97.2 255.255.255.0 st$
pixfirewall(config)# failover
pixfirewall(config)# .
No Response from Mate
