Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I was facing issue with the ACE normalization and that was stopping my SMTP traffic. When i disabled it globally my SMTP traffic is working fine. But due to the audit i cannot disabled it for all the traffic. I want to disabled the normalization ...
Hi, I am facing problem with one of my network scanner installed at remote Branch through theIPVPN link. Scanner is not able to send email but Same scanner works fine in the Head office LAN but when We are taking it to the remote branch it is not wor...
Hi, I have Wireless Client (172.31.250.x) in corpx segment (Secuirty 91) which are trying to access the webmail which is published over the internet. Email Server is located inside segment (security 100) on IP address (192.168.251.137). Clients are...
I am planning to install the Cisco WLC 5508 in the network.I will have two SSID one for the Corporate Users authenticated through the AD and one for the Guest Users.I want whenever guest wants to connect through the GUEST SSID they will get a web pa...
Hi, I hav ACE 4710, I am trying to configure a policy in which when specific Client tries to access the speicific Destination. ACE should not send the traffic to load balancing. It should directly send to the next Hop. I configred the below but didnt...
Hi,I have attached the capture when normalization was enabled (not working) and capture when normalization was disabled. Please review and let me know how to achive this by fine tunning the parameters.We are seeing lot of tcp retransmission error etc...
Hi,My email traffic is not working when passing through the ACE. When I am disabling the normalization on the interface level HTML email is working fine. Due to security audit i cannot disabled it for all the tarffic. I want to only disable it for SM...
Hi, thanks for the reply I applied the command on the lan segment but no luck.R01(config-subif)#do sh run inter fas 0/0.1Building configuration...Current configuration : 287 bytes!interface FastEthernet0/0.1 encapsulation dot1Q 1 native ip address 1...
