pix not able to view config on lms

[rpalacio]

hello,

we installed LMS 2.2 and along with the managed device is the pix 515. It says on the SNMP section of the pix the it supports at least the GET command..

Isnt this is all I need to have to enable LMS to view at least the configuration of the firewall?

But I was not able to get that? It was saying the device is unsupported.

Any help is appreciated..Thx a lot.

[mchin345]

The following URL should give you some idea,

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/cw2000/cw2000_b/lms/lmsmar03/index.htm