Network Security

I have two sites connected over the Internet via a VPN Tunnell terminated on PIXs at bothe ends. I want to implement QOS on the tunnel. I can mark the packets on the inside of each network and then implemet QOS on the router that connects to the Inte...

My sales rep is telling me that there is an unrestricted user upgrade for a cisco pix 501 but according to the following cisco link there doesn't appear to any such beast. Is there another link someone could send me to clarify this a little bit.http:...

I have encountered an issue with an Apple Macintosh network behind a PIX506 FW. The Apple clients are running OS X (10) with IP. The network will hum along fine and then some of the clients will not be able to connect to the Internet. The problem app...

LS, we just acquired an dsl line next to our leased line, the problem is that we would like to route our http traffic to the new dsl line and maintain smtp traffic to our leased line.the pix was setup with a dmz and in the dmz an ISA server, the clie...

Would it be possible to have vpn capabilities and wic 1 as ATM connectivity on the same cisco 1700 router? Ashley

Is there any automated file maintenance available for the log files created by the DFM FileNotifier. I'd like to leave this on for archive purposes? But I don't see anywhere to have this file rewritten at specific intervals.Thanks

hi i need a very basic info of placing a PIX in a small N/W.we hve a LL from ISP terminating in our router and we hve a small group of pcs(in private subnet).right now i hve connected my routers eth,pix public eth in a seperate switch.private eth por...

what are the commands to configure catalyst 2950 to work with ciscoworksthanks & regardsshoeb

Could anyone tell me all MIB's I need to manage a Catalyst 6500/Cisco 7600? Or better, do you know any documents where I could find this information?Thanks for your help.

Does PIX understand 802.1P ?

I have question about the behavior of PIX at 6.3.1. TAC's response is: it's in early deployment, insinuating that it is not fully supported, go back to last release. Looking at the software page, you have to go all the way back to 6.1 code train to g...

I have a PIX515 UR and have problems with it trying to failover. It is not in a failover configuration and has no failover cable attached. It's been fine and started acting up after applieing the 3DES/AES license. The config has "no failover". The PI...

Hi folks!, quick question........... i have a PIX 520 to play with. I was wondering, if it's possible to do failover with a lower model like a 515?many thanks

When selecting "Shun Connection" on the sensor, v4.1, the pix blocks the entire host...regardless of what ports or protocols are used. Anyone see this?Pix V6.3(1). The pix config shows the shun line the same for both shun host and shun connection. Bo...