pix route-map - match ip add - next hop...

[samuel.lam]

Dear All

I am urgent to use pix to use the route-map.

PCs are connected to pix, but want to add a special next-hop for a single PC.

but not like router, I dont know how to apply the policy on the interface.

There is no routing protocol.

route-map samuel, permit, sequence 10

Match clauses:

ip address (access-lists): 11

Set clauses:

ip next-hop 192.168.1.150

route-map permit, permit, sequence 10

Match clauses:

Set clauses:

[mhussein]

Hi,

Not sure if this is possible. The closest thing to a route-map is policy nat; where traffic traversing the pix can be source/destination translated.

Could you explain what you are trying to accomplish?

Regards,

Mustafa

[samuel.lam]

Thx for your reply.

Thx all.

The case is all the IP is real.

I want a customer no need to change the default gateway/IP ,an the pix will handle its outgoing

traffic

But this customer will eventually not using this route for outgoing, we get another pix for outgoing his traffic, but do not want to change customer's IP setting.

My idea is want to in between insert a router like function (but not router enable) then use that routing for outgoing.

Basically, how can I use pix to set for

a source ip from this range will point to other next-hop.

thx very much