pix software upgradation

[nataraj_v]

Dear all,

when we trying to upgrade our pix software from 6.2(3) to 6.2(5) using monitor mode

we are facing the following problem

monitor>

monitor> int 1

0: i8255X @ PCI(bus:0 dev:5 irq:12)

1: i8255X @ PCI(bus:0 dev:3 irq:255)

2: i8255X @ PCI(bus:0 dev:2 irq:255)

3: i8255X @ PCI(bus:0 dev:1 irq:12)

Ethernet auto negotiation timed out.

Ethernet port 1 could not be initialized.

monitor>

can anybody have idea about this problem

Thanks in advance

Regards

Nataraj

[prasadrp]

Hi

There could be 2 reasons for this :

Check the speed/duplex setting on the switch.

Most of the time, its a faulty cable issue. Please ensure that the cable is good.

I put my bet on the 2nd point. If you are connecting the pix directly to the PC, do use cross cable. Also int 1 means 2nd interface of the Pix.

[s.elmrabet]

Hi

If you have the version 6.2(3) you can upgrade you iso using the config mode instead of the monitor mode

use the command

copy tftp flash

Best Regards