09-15-2003 03:13 AM - edited 02-20-2020 10:59 PM
Hi
I am going to upgrade my PIX(520)software version from 6.2 to 6.3(3).But I want take backup of existing version 6.2
copy flash tftp--This command does not exist.
Is there any way to copy existing software for backup ??
Please help me.
Ishwar
Solved! Go to Solution.
09-15-2003 06:17 AM
Hi Ishwar,
Please send e-mail to scott (cisco) also, please read the following post (posted recently):
Thanks - Jay
09-15-2003 03:27 AM
I would assume you are downloading the update? I believe Cisco lets you download the previous versions too. Also the version that is installed is normally shipped with the PIX on CD.
Check out:
http://www.cisco.com/cgi-bin/tablebuild.pl/pix
For the list of images.
09-15-2003 03:54 AM
HI
Unfortunately, I do not have any right to download it.
I Just want to know that how can I take backup from PIX itself.Because I have to revert back to old version if any problem occure.
Ishwar
09-15-2003 05:47 AM
You cannot pull the current image off of the PIX. Send me an e-mail (sclayton@cisco.com) with a current 'sh ver' from the PIX and I will post the code for you in case you need to revert back after the upgrade.
Scott
09-15-2003 06:17 AM
Hi Ishwar,
Please send e-mail to scott (cisco) also, please read the following post (posted recently):
Thanks - Jay
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide