Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,One of the features mentioned with version 7 is the ability to upgrade with zero downtime (if you have a failover unit) - I've had a look around and it's not clear on the procedure for this. With PIX 6.x when I upgraded one of the units the failov...
Hi,After upgrading to IOS version 7 connecting to my PIX externally via SSH fails (Using PuTTY). I've tried changing the SSH versions allows to both SSH version 1 & 2.The PIX logs (IP's removed):315011: SSH session from X.X.X.X on interface outside f...
Hi,I have the situation where I'm trying to create an outbound rule but PDM changes the interface to point to an interface with a higher security level. Testing it I found that it then allows access to the higher security interface.Please HELP!
Hi,I am having an issue with PIX 6.3(3) creating a static inbound tunnel to web servers running NLBS/WLBS in both unicast and multicast mode. Has anyone been able to get this working?Thanks
Hi,Can someone explain why I need security levels on a PIX - they seem VERY limiting. Or prehaps I don't understand the logic.Example. Interface E 0 - Internet Interface E 1 - DMZ 1 Interface E 2 - DMZ 2 Interface E 3 - DMZ 3 Interface E 4 - Com...
Hi Mansoor,To answer your question statefull inspection will ensure that the flow of TCP SYN, TCP SYN ACK etc is following during the TCP session setup. Thus if you are saying the HOST B establishes a NEW connection following the standard SYN then th...
The process on the 525 was.1. Delete ASDM to make space for the new image.2. TFTP the new firmware into flash.3. Remove the boot system flash:/4. Add the boot system flash:/5. Confirm with "show run | include boot"6. Save config and reboot.7. Delete ...
