PIX To ASA 8.3 Conversion

Victor Norman · ‎04-17-2013

Conversion utility is available here (link)

Jouni Forss · ‎04-17-2013

Hi,

I am not sure if I understood you correctly here.

1.) These are simply "network-object" under some "object-group network". They arent configured any differently in the new software

2.) To give configuration for this NAT configuration I would have to know the access-list configuration also

3.) These are also "object-group service" which are configured the same way in the new software also.

- Jouni

Victor Norman · ‎04-29-2013

Hi Jouni,

Never mind, thanks for attempting to answer my question though.

Also found this link for conversion.

Jouni Forss · ‎04-29-2013

Hi,

Seems the above tool is only able to convert Static NAT configurations to the new format.

I have seen it before but not used it myself.

I made a document about the new NAT configuration format some time ago

Theres also a good document comparing the old and the new NAT configuration formats

- Jouni

Victor Norman · ‎05-03-2013

Thanks a lot Jouni

Jouni Forss · ‎05-03-2013

Hi,

Were you able to migrate the configuration?

If you have found the information helpfull, please take the time to rate answers

- Jouni