PIX to Sonicwall with Dynamic IP

[gtate]

Anyone have this working...

PIX (6.1.1) with static IP, and Sonicwall firewall (6.2.0) with a dynamic (dsl) ip address?

I've sort of got it working by disabling Mode-config and XAuth on the 0.0.0.0 crypto-map. It makes it through Phase 2 and sets up the SA. No traffic goes from the PIX to the Sonic though. I'm not even sure this is a good solution as I can't use the Cisco client VPN now.

Any tips would be nice! Thanks.

Glenn

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.