02-02-2004 11:52 AM - edited 02-20-2020 11:13 PM
Anybody here know if the "ip verify reverse-path" commands are enabled by default for this release? I just noticed these were on when I upgraded the OS.
TIA
- Jericho
02-03-2004 05:32 AM
This command is disabled by default. You can get more information about this command from the link below.
http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727a9.html#1053009
Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community