Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an Active/Standby pair of ASA5510 firewalls, configured for ISP failover and I have IPsec L2L tunnels to my two remote sites. The remote sites also have Active/Standby 5510s. If my primary ISP connection fails over to the secondary ISP, what...
I have a remote office where this REAP is deployed. My clients regularly have problems getting connectivity through this REAP. I have to reset it through the WLAN controller for connectivity to be restored. When the problem occurs, I frequently se...
Has anyone run across this? We have 3 7936 phones in conference rooms. When we place calls on any of these sets, the connection is made and the remote party can hear us, but not vice-versa. We cannot hear the remote party through the 7936. The ph...
I'm planning to use this at a remote branch office. Just wanted to know if this also provides voicemail services, or do I require another piece of hardware/software? I'm told that the express version can support 100 hrs of voicemail for those remot...
We are using 2 full unrestricted licensed PIX525s which are load balanced in a sandwiched config:public traffic ---> external load balancer ---> PIX525 farm ---> internal load balancer ---> server farmmy question is: i need to pass traffic from the ...
Gilbert, just to be clarify, I'm using a single pair of ASAs in Active-Standby mode. I have my backup ISP link connected to an interface on each ASA, but external traffic flows to my primary ISP on the ASA's Outside interface.From your reply, I'm co...
This issue concerns me as well. I wanted to deploy it for users, but I need to know how to pass the username so that the appropriate home directory is accessed. Any VPN experts out there?
Thanks but I don't have the config options you refer to. The AP has always been in REAP mode, and provides connectivity to clients. However, after some time they lose it. This corresponds to the WEP error message in the logs. When the REAP is res...
We had this problem too. The fix recommended by Cisco was to disable VAD (voice activation detection). It made a world of difference. Previously we were having voice quality issues on these phones because the detection was too sensitive. It was c...