Im very much a noob on this but i need to move from a pix 515e. V 6.3 to a asa v 8. From what ive read i can use the pix to asa tool to get the converted configuration file to the new asa. So far so good, however, the pix has conduits which i read must be converted via the occ tool. So i ran the pix to asa conversion then ran the occ tool on that output but i keep getting errors. It is not liking the nameif outside, inside, and dmz lines. If i manually edited them out before i run the occ tool it runs but warns there are no interfaces. (true. I just took em out). So how should i proceed? Any ideas is appreciated.
Sent from Cisco Technical Support iPhone App
