Port Forwarding With Cisco ASA 5510

[JMullisYPG]

i have tried dozen of configuration examples to port forward on my Cisco 5510. here is

my scenario.

i have a asa with a outside IP address of 140.32.121.5. behind this firewall i have a cisco MWR 2941 that i would like to connect to via telnet. its inside ip address is 10.10.10.2. my reasoning for this is because i cannot SSH or telnet from a ASA so i need to have the ASA push my telnet request to the router on its inside interface.

i have tried some NAT examples but i am very green with NAT. i have also built access lists that look like the follow " access-list 101 permit tcp any 10.10.50.2 eq 23. and then tied the access-group 101 with the outside interface. this also with no success. can someone please show me what i am doing wrong? your help is greatly appreciated.

[Allen P Chen]

Hello,

What version of software is the ASA running?

If your ASA is running software version 8.2 or below, here is a sample configuration for port forwarding on the ASA.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708b4.shtml#t10

Hope this helps!