01-11-2002 02:14 PM - edited 02-20-2020 09:57 PM
interface on standby pix shows in 'testing' state from primary. but shows as normal when logged in from standby pix. what is the problem and what can I do to correct it?
01-11-2002 02:22 PM
actual message displayed below:
message.
--Removed post per user request (mbgoodman)--
01-15-2002 09:11 AM
Regardless of the failover state on the primary (showing Normal) replace the cable (known good). Check your IP addressing on that interface and make sure they are on the same subnet. Check your PIX code versions to make sure they are identical (and current). Check your hardware to make sure they are identical (Failover is only supported on like models with identical hardware configurations). Just some things to try before calling Cisco.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide