Network Security

How does the PIX handle initial IP fragments? Does it automatically forward any initial IP fragment that passes the ACL's or does it hold the fragment until all fragments have arrived?Thanks.Kevin

A customer has setup a VPN between a PIX 501 (6.2(2)) and a FW1NG FP3.They are using 3DES, SHA, DH Group 2.When they test the performance the throughput is only about 500Kbps. If they connect using the FW1 SecuRemote klient instead they got a through...

Is there a way to configure a PIX 506 running 6.2(2) code to utlize both the global (outside) 1 interfacenat (inside) 1 0.0.0.0 0.0.0.0 0 0 commands andstatic (inside,outside) tcp interface www 172.18.1.101 www netmask 255.255.255.255When I try the c...

I have configured Failover on PIX firewalls (515). I tested the failover with and without giving Failover IP address on PIX interfaces and it worked on both times(but found that with failover IP backup pix came up quickly). Is their any specific tech...

We had 2 PIX firewall (525-UR) in Failover mode and recently i added third 1 Port NIC card on the Pix Firewalls(total of 8 ethernet ports 4port +1 port + 1port+1 inside and 1 outside) . As soon as I added the new NIC card on Firewall it crashed and s...

Hi allI have successfully established a VPN tunnel between the VPN dialin client and my PIX 515 firewall, i can even manually map network drives and browse these, but i am unable to browse the entire network from explorer or gain internet access even...

Hallo iam trying to configure ACS & my Network devices to restrict the use of some commands for a group of users, i have another group ( Networking group) this group have the privileged level 15 and should be able to do evry thing. The group that i w...

I want to allow only three hosts on my internal network to be able to access the internet. Using the Config Guide for Cisco Secure PIX Firewall v5.2 , I entered these commands. When I do No one including the three select hosts can access the internet...

I downloaded the WebSense evaluation software, and have been playing with it w/ our Pix 515. My question I have, which WebSense doesn't seem to know is: can you specify not to filter for certain hosts? Is the URL filtering on the PIX an everything co...

Now that PIX's use ACLs, can they also do them based on MAC addresses?

Is there any thing needed to activate a tunnel ussing 3DES between a Cisco PIX 501-50 & a CIsco 3640 with IPSEC (3DES) IOS 12.1.18? When configured for DES it works but 3DES does not.and yes I changed the transform sets and Isakmp policies on the roi...

Hi,I've been reading on this but can't find any answers...PIX 515 with 3 ethernet inside - ethernetoutside - leased lineadsl - adsl lineThe leased line and adsl line are from different providers, and therefore have different address ranges and gatewa...

I see that the port only does half duplex right now...Is it possible to set it to full anytime soon?