09-23-2002 09:02 AM - edited 02-20-2020 10:15 PM
Hello,
I have a PIX 525 and have a problem removing a line from configuration. What happened:
I tried to add an ip route with 20 bits subnet mask (255.255.240.0) but it was accepted as 255.255.0.240 (don't know why and I could see I typed it correctly in the terminal emulator). Now if I use "no ip route ..." it gives me error "Invalid IP mask 255.255.0.240).
I added the correct route later, however don't know how to get rid of this wrong one. Any idea?
Thanks a lot,
Ali
09-23-2002 09:36 AM
I have tried removing commands but it wouldn't let me, so I did a wr mem, then removed it and it accepted it. Try that.
Steve
09-23-2002 09:59 AM
Thanks for your response but unfortunately it was not the case for me. I still cannot remove it, after wri m.
09-27-2002 01:41 PM
I have experienced the same issue and it was with version 5.3(1) software.
Here was my line, albeit not an IP route, but still a bogus line I could not get rid of:
outbound 10 except 192.168.0.100 0.0.0.252 0 tcp
I upgraded the software to 6.2(2) and the line "magically" disappeared all on it's own, almost like the software knew to get rid of it.
Hope this helps.
-Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide