Hi,I have a 6509 with FWSM in module 4. FWSM is configured in single context mode. After I configured passwords and authentication on the FWSM, I can no longer access the module using "session slot 4 processor 1" when connecting to the 6509 switch vi...
Hi,I have problem with enabling dhcp on my 2611 router which has 11.3(10)T IOS. It doesn't accept "ip dhcp pool ..." command. Is it because of old IOS? If so, which version ahould I have as minimum to be able to setup DHCP and NAT?Thanks in advance,
Hi,I have a ASA5520 with one internal, one DMZ and two outside interfaces to be connected to two separate ISPs routers.I would like to use both ISPs for internet traffic in one of these ways:A) Route traffic based on source IP (separating desktop and...
Hi,Can someone please confirm this for me? Based on the following paragraph from "Cisco Security Appliance Command LineConfiguration Guide", you cannot use the appliance for VPN connectivity if you setup virtual contexts. It seems to be a big limitat...
Hi,I am in the process of proposing a Cisco firewall/VPN solution for a customer. It's a SMB size company (currently about 50 users expected to grow to over 150 in the next few months). At the beginning about 10 people need VPN access to the LAN but ...
Thanks for your quick reply. My problem is the fact that I cannot go to enable mode with the script or even run anything else at user level prompt. Also my intention is to copy and paste the running configuration (wri t and then copy-paste the output...
Thanks a lot to both of you for your help. I will refer to your recommendations in the future.One question regarding PDM. I have setup PDM but have not used it to modify access lists as I thought it would eventually translate the changes to what I do...
Thanks for your response. VLAN is working as I was using the same ports on SSR8000 for previous firewall which was an IBM SecureWay firewall. PIX just replaced that one using same ports and same config on SSR8000.As well, I have already added routes ...