Proper NAT Config with port number for public IP

[dbuckley77]

We have a rule in our firewall to NAT an IP for a system on the inside to the IP address of our outside interface so that users may publicly access the system via a web browse using the outside interface IP with port 8100.  It was working but the  NAT rule got deleted and now I cannot get it to work again.  I amusing the GUI v 8.2

To go through the ASA settings for this rule:

It's a static NAT rule.

Original

Interface = inside

source = hostname with internal IP

Translated

Interface = outside

Use interface IP Address is slected

Enable PAT is checked

Protocol = TCP

original port = 8100

tanslated port = 8100

What do I have wrong?

[dbuckley77]

Yes the ACL has been created.  the ACL was created before the original NAT rule was deleted and it was working then so I know the ACL is good.

[Marius Gunnerud]

If you run a packet tracer where does it indicate that the packet is being stopped?

--

Please remember to select a correct answer and rate helpful posts