RADIUS config for VRF-aware VPDN multihop tunnel

[alexserkin]

Hi,

Can't find the LNS config directives those will lead to get complete(!) vpdn profile from radius.

The configuration is:

LAC-LNS/PE-LNS/CE

LNS/PE - provider edge lns that we want to configure using radius profile for vrf-aware multihop vpdn so that incoming tunnel is switched out to LNS/CE in one of the vrfs configured on LNS/PE.

The "vpdn tunnel authorization " command lets me get the profile for ingress session coming from LAC, but in order to switch the tunnel further to LNS/CE i have to config vpdn-group on LNS/PE. Is it possible to make a RADIUS profile that LNS/PE will use for both ingress and egress tunnels?

[mheusinger]

Hello Alex,

I would like to point you to this forun into another section. There is currently a "Ask The Expert" about MPLS VPNs at http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dda563c

Maybe it will be more suitable to address your questions there.

Hope this Helps!

Regards, Martin