Rebooting the standby ASA

[mahesh18]

Hi Everyone,

If ASA is in active / standby failover.

And for some reason if you need to reboot standby ASA is it good practice just to reboot standby?

If standby is rebooted should it syn all the config over failover link from active ASA?

Regards

Mahesh

[Elshaday G]

"This active FWSM was sending its configuration to the standby FWSM and wouldn't accept configuration changes."

I received this error message after I created  some new ACL rules on my FWSM and tried to apply the change. I used the 'failover suspend-config-sync'  and saved the running-config to flash, then  'no failover suspend-config-sync' but the problem is still there. I appreciate your help to fix this issue, thank you.