Hi all,
I'm reimaging a bunch of FP4110 appliances. They were shipped with a very old version of FXOS and upgrading them (with intermediate steps) just would take too much time.
So, I started with the section 'Recovering from a corrupted filessystem' as described in the FXOS 2.2.1 Config Guide (page 94). This way, I can wipe the disk and put the final version on it.
When I'm done with reimaging the appliances, the WebGUI doesn't work anymore... So something went wrong during the reimaging process. Because I didn't had error messages during the process, I think step 8 might be the problem:
Step 8, 'Upgrade the FXOS Platform Bundle' (page 99)
--> I'm unable to determine if the process completed successfully or not.
scope auto-install
install platform platform-vers 2.2(1.66)
The manual states that the process can take up to 30 minutes. But how can I know for sure if the process is done or not?
Is it required to download AND install the bundle? Or only download the bundle?
Using the command 'show firmware monitor', I do not understand what indicates the process (installation) is ready.
So maybe, after 30 minutes, the process wasn't done yet with a non-working WebGUI as a result?
Anyone with experiences on that? Any help is appreciated!
