05-12-2015 10:46 PM - edited 03-11-2019 10:55 PM
Hello.
i have configured redundant interface in ASA5550.
interface Redundant1
member-interface GigabitEthernet0/1
member-interface GigabitEthernet1/2
nameif Outside
security-level 10
ip address 192.168.1.1 255.255.255.0
But now i need to remove configure of redundant interface. So will it remove any configurations related to this named interface(redundant interface)? If so Is there any way to preserve this or will i just be recreating ACL's, static nat , etc?
05-12-2015 10:58 PM
Yes, if you remove Redundent Interface, then you need to recreate ACLs, static routes and NATs.
05-13-2015 12:09 AM
You need to reconfigure any assignment of commands to that interface. That are commands like nat, ssh, http, access-group (but not access-list) and so on.
Just do a
show run | inc Outside
to see all commads that are assigned to the interface.
After changing the interface, just reapply the commands.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: