Redundant Switching With Single Sensor

[NotMeHere]

I have a redundantly switched network. I'm wondering if I install a second NIC in my 4235, can I use it to watch traffic from two points in my network by using an interface on each switch that has all the VLANs I want to monitor as SPAN sources? Or will this cause the sensor a problem?

Below is a link to a topology drawing for what I'm considering. Also is there documentation on setting this up on the sensor?

http://memimage.cardomain.net/member_images/11/web/755000-755999/755948_7_full.jpg

[owillins]

The documents Configuring the Catalyst Switched Port Analyzer (SPAN) Feature and Configuring SPAN and RSPAN has more details about SPAN.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015c612.shtml

http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_guide_chapter09186a00801a6ba9.html