06-07-2013 07:27 AM - edited 03-11-2019 06:54 PM
Hi.
I have small question.
If I run
'reload in 1:00 noconfirm '
Does it mean, that I can make any config changes. And if I don't run 'wr mem', it reload with old config aftrer one hour?
Is there any limitation running commands, i.e. can I safely make failover settings remotely and boot startup-config if I do any mistake?
06-07-2013 09:32 AM
Hello It means,
That the firewall will reload in one hour and it will not prompt you to let you know about if you really want to reload it ( No user confirmation)
The only way to stop it is with reload cancell
Regards,
Julio
Hey remember to rate all of the helpful posts, as important as a thanks (keep us motivated)
06-08-2013 08:11 AM
Hello.
Ok, If I don't cancel and don't make write it will reload in anyway.
And there no any exceptions?
06-08-2013 10:03 AM
Exactly,
If u set it to reload withing an specific data and you add the no-confirm keyword.. It will just happen.. Unless you cancel it,
So the no-confirm only for experts setting schedules hehe
Regards,
Hey remember to rate all of the helpful posts, as important as a thanks (keep us motivated)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide