Removing An Object network

[sadik.bash]

Hi all,

I created an object network and assinged it to a dynamic NAT. Then, I tried to remove/delete that object network but it keeps giving me a error message " ERROR: unable to delete the object configuration. object (obj-PUB_NAT) is being used. "

Also, I tried to disable that NAT command but I keep getting  this warrning message " 

no nat (INSIDE,OUTSIDE) dynamic obj-PUB_NAT

                        ^

ERROR: % Invalid input detected at '^' marker"

Much appreciated.

Best, ~sK

[Julio Carvajal · Accepted solution]

Hello Sadik,

I would say you are using auto nat.. That being said you should be inside the object configuration in order to delete it so for this to work do the following:

object network asdaksdfajsdsa

no nat (INSIDE,OUTSIDE) dynamic obj-PUB_NAT

Then you can safely remove the object network

Glad that I could help on this one,

Regards,

Julio

[sadik.bash]

That did it!

Thanks again, Julio!