Sample PIX and Router connected to INternet

[j.hato]

Dear ciscoer,

Any sample config PIX connected to the Internet with Router. The router using the IP legal and router's ethernet 0 using 192.168.0.xxx. PIX ethernet0 using 192.168.0.xxx and the PIX's ethernet1 192.168.1.xxx. Where should I NAT the IP legal from ISP.

LAN(192.168.1.xxx)

|

|

PIX Inside (192.168.1.xxx)

|

PIX Outside (192.168.0.xxx)

|

|

Router Ethernet 0 (192.168.0.xxx)

|

Router Serial 0 (202.xxx.xxx.xxx)

Thank YOu In Advance

HATO

[ywadhavk]

Hi Hato,

You could do NAT 0 on the pix and have the edge router do the NATing for you. This would be the simplest way to get it working.

Other option is to configure PPPoE. Below link is the FAQ for the PIX configuration.

http://www.cisco.com/en/US/partner/products/hw/vpndevc/ps2030/prod_configuration_examples_list.html

Thanks,

yatin