Saving firepower configuration changes when in CLI

[Waterbird]

Saving your changes:

For an ASA with firepower services, if you make a change to firepower CLI configuration such as change IP address in it or something like that, does the change get saved automatically even if you power cycle, or do you need to type some command to save the change permanently?  Or do you need to exit to the ASA and write mem in ASA mode to save the firepower module changes?

[phil.hydea · Accepted solution]

No need to do a write mem as it's committed within the Firepower shell upon
command execution.

You can use the show commands to verify your intended change has taken
affect.