SDM not showing access lists

[wayne_lanway]

Hi all,

I have two access lists configured on my Cisco 1841.

These access-lists have been created in IOS at the command line but when i log into the 1841 via SDM i cannot see any of the access lists that are configured. I am looking in the following place

configure>interfaces and connections>edit firewall policy

Any suggestions please?

Cheers

[Federico Coto Fajardo]

Hi,

Instead of:

configure>interfaces and connections>edit firewall policy

Should be:

configure>Firewall and ACL>edit firewall policy

correct?

If you don't see the ACL there, please copy/paste the ACL here from the CLI and where it's applied to.

Federico.

[Scott Nishimura]

Hello.

I think the firewall/acl is related to the acls associated with the firewall.

Please check under additional tasks, and there should be an ACL editor which you can edit.

let us know.

thanks,

scott