show interface command on FTD 1100 doesn't show duplex

[tato386]

I tried in the FTD CLI and also in "system support diag" and can't seem to find duplex status.  Where did they move this too?  FTD is v7.4.2.2

Thanks

[MHM Cisco World · Accepted solution]

FP2110-2# scope eth-uplink
FP2110-2 /eth-uplink # scope fabric a
FP2110-2 /eth-uplink/fabric # show <interface> detail

[tato386]

Thank you, this worked but geez, why did Cisco remove (or forgot) to add to simple "show" command!?!?

[MHM Cisco World]

Sorry for late reply 

The reason I think is that firepower build on linux OS' which is not simple like old asa.

MHM